Drop(N)Tell® is a unique, bi-directional indicator device label that uses mechanical action to snap an arrow from red to blue in the direction of the impact. Indicates when Shipment / Parcel has been Dropped or get Shocks or Mishandled. It includes a system of labels that warns all handlers of a monitoring device.

Unlike others, our Drop(N)Tell® has a special lock pin that guarantees they will not be triggered upon arrival at our customer's door.

• Integrity of the supply chain
• Validation at point of use
• Product Authenticity
• Quality / Regulatory Compliance
• Prevent Damage & Save Costs

The DROP-N-TELL system includes two warning labels and is manufacture in six different G-ranges of 5G, 10G, 15G, 25G, 50G and 100G that allow all sizes and weights of shipments to be tracked appropriately. The device monitoring 5 times the force of gravity is very sensitive. The device monitoring 100 times the force of gravity requires a greater impact to activate.
Attach the DROP-N-TELL to your product or shipping container by removinng the liner on the back to expose the adhesive or screw/nail it using the holes on each end.

Resettable DROP-N-TELL
The resettable DROP-N-TELL can be reset and reused upto 50 times. Simple bend the end of a paper clip and push it gently in the holes on each end of the indicator until the arrows shows red. Upon receiving an impact, the arrows will show blue.

Non-Resettable DROP-N-TELL
This DROP-N-TELL can be used only once. It cannot be reset. Remove the bar across the arrows. Upon receiving an impact, the arrows will show blue

Optional Features:
A large 8" x 5 " companion label pictured below is also availabel for a small additional charge.

Instructions for using and setting the Drop (N) Tell Impact Indicator
This carton contains equal numbers of DROP (N) TELLS, warning labels and bill of lading labels to be used as a system for monitoring your product during transit. We suggest that the bill of lading labels be placed on the bill of lading to notify the carrier or consignee that the shipment contains an impact monitor. The warning labels should be placed on the top or side of the package. The DROP (N) TELL may be placed on the inside or the outside of the package or on the product.

Mounting
Mount the DROP (N) TELL with either adhesive back tape or 2  No. 6...32 screws. There is pressure sensitive tape on the back of the indicator. Remove the liner from the tape and press the uint to a flat surface on the package or on the product to be monitored. The DROP (N) TELL impact indicator must be align with arrows pointed toward the direction of shock to be monitored. Three units are needed to provide complete three-dimensional readout (six directions).

To activate the Resettabel Drop (N) Tell
A small 1/16 -inch hole is provided in the center of each end of the plastic housing for the purpose of activating and resetting the unit. This hole is directly in front of the arrow point. A small paper clip with one end bent out can be used for activating and resetting the unit. Push the wire end of the paper clip into the small hole until the arrow snaps back into hiding and the spring is reset. Apply only enough force to reset the arrow and spring assembly. The arrow will snap quicky into a covered position and a sligh snap can be heard. The impact indicators is now ready to use.

To activate the Non-Resettabel DROP (N) TELL

Pull the metal pin on the side of the DROP (N) TELL. It cannot be reset; therefore, care must be exercised not to trip the device as the pin is being pulled.

*Vanprob Solutions is Authorized Representative of Drop-n-Tell in India.